Auxfan output not working with temp activation. Plz help
So my relay is wired up correctly to my fan and it will turn on with rpm activation but won't turn on with temp activation, has anyone else had this problem ? Lt10s ecu
|
Anyone ? I will probably just wire it up to a toggle switch, then later to a thermo.
|
Can you post a screenshot showing the settings? That's weird. I suspect that the aux output has a 2nd parameter set somewhere.
|
also make sure your microtech is reading the temp sensor correctly on the main screen.
|
Auxfan output not working with temp activation. Plz help
I can take a pic but I assure you the settings were both set to off for rpm and map, no matter where I put the temp setting (even at zero) , it won't activate.
However it will activate with rpm activation, the thermosensor works and clearly gets a reading but it won't turn on. |
Auxfan output not working with temp activation. Plz help
To my knowledge there are only 3 settings for the aux output #1
AuxRpm_On AuxMap_On AuxFan_On Is there any other setting that could conflict with the function |
I can't think of a setting that would conflict other than the aux functions.
AuxMAP_ON and AuxRPM_ON must both be set to zero for AuxFAN_ON to work. |
By zero you mean off ? Also I tried using the map to turn on function and that will not work either. The only function that works is rpm on.
Don't understand what I'm doing wrong here. |
Don't remember if it is zero or "off". Maybe someone else can see if you post screen shots.
|
Pretty sure it's off according to the manual
|
what colour wire did you use?
sounds like you used the wrong one |
Aux input 1 iirc
|
INPUT?! There's your problem.
|
Actually the problem was it was on on aux output 1, come to find out that's only used for rpm, aux output 2 is for the fan
|
I have the same thing going on, mine is connected to output1, ill switch it to 2 ans see whats up
|
1 Attachment(s)
Fix your problem izzy?
|
All times are GMT -5. The time now is 03:50 PM. |
© 2024 MH Sub I, LLC dba Internet Brands