2200cc injector start on LT10 basemap
Hey guys,
I need to get the car started and ilding at least to get it out of the basement so I can get it on the truck to get towed for the exhaust. Can someone please give me some numbers to get her started and idling? Where do I start? Staging? I understand the idle map will need to be adjusted but not sure what to? And what mS it should be running... I did start the car the other day on 95% staging but after about 5 seconds it stops because it was flooded with fuel... It's also on e85... Any help would be greatly appreciated! its still on stock standard base map for 550cc injectors also they are 2200cc in primary and secondaries. Thanks in advance! |
With 2200CC injectors you are quadrupling the amount of fuel you are shoving into the engine, so you'll want to approximately quarter the pulse-widths on any base map set up for stock 550CC injectors.
|
Nevermind.
ALL good.. Just changed the Mixtrim to minus 40% and bingo! :) |
I have a lt10c with 4 2200 and start right up np
|
Did you have to adjust your maxtrim on your microtech to get it running on e85.
|
All times are GMT -5. The time now is 03:13 AM. |
© 2024 MH Sub I, LLC dba Internet Brands