20B Spark Trig setting for Microtech LTX-12
After having some problems trying to time my engine I was advise to check the ECU setup 31 screen to see what the Input and Spark Trig settings were. The manual says both should be +pos. However Spark Trig is set as -Neg on mine and the other option show SER4. No option for positive. Can any other 20B owner with Microtech confirm if it should be on SER4 or if it is fine where it is?
Will post in ECU section as well of course but figured it might be more 20B specific! Thank you Lee |
posted on your other thread.
Maps matrix Config 6 Firing sequential LOAD MAP sensor DWELL time base Input +POS Spark IGBT Timing chk OFF RPM_on 2500 Trim#1 0 Trim#2 0 Trim#3 0 SHIFT 9750 dash it's 20b single turbo. worked perfectly. |
For the record this is mine:
Setup Screen 31 Maps – normal Config – 06clyd Firing – Sequential Load – Map Sensor Dwell – Time base Input Trig - +Pos Spark Trig - -Neg Timing Check – Off RPM on – 4500 Log Map_On – Off Log Sample - +01 Log Spare – +00 Log Shift – 7000 Dash Water – 99C Dash Air_Temp – Off Dash Boost – Off Dash |
All times are GMT -5. The time now is 11:47 AM. |
© 2024 MH Sub I, LLC dba Internet Brands