need a ve table for 680cc pri 1350cc sec
 

like the tittle say I'm looking for a ve table for 680cc gslse injectors and 1350cc secondaries and also need the fuel requirement that i have to set the injectors on the engine constant box

The fuel table is not determined by the injectors, it is determined by the amount of air your engine needs and to a point the AFR you are trying to run (assuming the incorporate AFR setting is disabled). Since each engine and its specific mods are different, I suggest tuning specifically for your engine instead of using someone else's table.

The size of the primary injectors can be used to generate the Required Fuel value in the tuning software. The size of the prmary and secondary injectors can be used with the stage injection feature to set up stagged injection properly for your injectors.

Ken

So how you set the fuel req on the engine constant section in tunner studio. What shlould I put to achieve a 1300 a/f ratio.

You open up the reqfuel calculator, and enter the appropriate information, and it'll set the required fuel for you.

Ken

got the fuel issue working thanks