Help with MS3x & FFE trigger wheel new install
Hi,
I have a new ms3x v3.57 install using a FFE 36-1 trigger wheel and hall sensor that wont fire. Im not getting a signal from the FFE wheel / sensor. Setting are per FFE instructions: Toothed, Falling edge, single wheel - missing tooth etc The sensor is wired as follows, using shielded cable that came in the loom from DIY Autotune: Signal -> Pin 24 (Main board) Ground -> Pin 2 (Main board) +12v -> Switched 12v Is this wired correctly? Do i need to change/set the jumper up differently? Or adjust any pots? Anything else that need to be setup or changed? Thanks |
IIRC I had to wire them backwards to get the two I have done to work.
I am about 90% positive it was awhile ago. |
Originally Posted by Logan Reinisch
(Post 12216522)
IIRC I had to wire them backwards to get the two I have done to work.
I am about 90% positive it was awhile ago. |
All sorted, turned the pots the opposite way to the manual and every guide I have read and it fired up 1st go.
|
wierd, the pots affect the hall signal? I thought they were for tuning VR only.
|
All times are GMT -5. The time now is 11:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands