Cas wiring/ No rpm MS2
hey guys i just finished up My megasquirt mods as per aaron cakes guide
and everything seems to be working tps, Coolant The 24 tooth wheel Has 2 different ways to be hooked up? I assume it would only have one way and the 2 tooth wheel would have the multiple ways? (because you build this circuit) So im confused when i look at these 2 wiring diagrams http://www.aaroncake.net/rx-7/megasq..._schematic.gif Click link: http://stuff.pw.cx/Megasquirt%20MS2%...azda%20CAS.pdf |
When you follow a Megasquirt writeup, you need to only follow one writeup.
The external wiring diagram on my site matches the instructions on how to configure the Megasquirt internally. The PDF instructions have a different wiring diagram because the PDF instructs you to configure the Megasquirt internally a little different. If you intend to use the external wiring diagram from my website, you need to follow these instructions to configure the Megasquirt internally: http://www.aaroncake.net/rx-7/megasq...andmodding.asp |
i did that but i get no rpm signal I'm using msextra 2.1.0
Im using a drill to spin the cas |
MSQ? all pots turned fully counter clockwise? composite log?
Ken |
Ill post the msq when i get home
the pots are fully counterclockwise to just before the click No composite log, i get nothing from the triggers its as if its not connected... im going to triple check the harness but i cant see it being in there the only thing im not 100% confident on is the MS itself Again ill post the msq when i get home maybe its something obvious in there |
Getting nothing from either of the triggers is highly unusual. I've never seen it happen when the MS and the harness are built correctly.
I will check the settings though. Ken |
Do you have any diagnostic tools such as a scope or frequency counter?
|
All times are GMT -5. The time now is 02:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands