MAP limit quick tip
 

While doing some street tuning at 198 kPa I found that with the MAP limit set to 210 it would sometimes kick in around 203-205. After setting the limit to 215, I had no issues. So I'd recommend setting the limit to around 15 over your desired boost level to account for slight fluxuations without hitting the hard limit.

What size MAP sensor are you running?

EB Turbo

Using the internal 4 Bar on the G4 RX

With such a high limit on your map sensor, small changes in MAP will have larger changes in MAP voltage and you will tend to have more fluctuations in MAP readings. If you went to a smaller MAP sensor you wont have the issue above. There is nothing wrong with what you have but if wont be running anything above 250kpa a 400kpa map sensor is a bit overkill.

EB Turbo

interesting... i have the 4 bar external with my V88 and will check it.

thanks

howard

This is simple math. 0-400kpa map sensor on a 0-5v scale is 0.125v per 10kpa. Let say you use a 0-300kpa sensor it is 0.167 per 10kpa and 0-250kpa is 0.2v per 10kpa. Or you can look a the total amount of the sensor being used. If you will only see 250kpa max on your 4bar sensor you will only use 62% of the map sensor scale. Again, don't think this is very bad unless your sensor is almost double the amount of the max manifold pressure you will see or if you are picky and want to maximize your resolution.

EB Turbo

I mainly wanted to share the info so other's wont run into the same Issues that I did. I do not have an external MAP sensor installed. I am only using the internal 4 Bar sensor that came with the ECU. Believe the same sensor is also installed in the following Link / ViPec units:

Vipec:
V44

Link:
G4 Storm
G4Plus Storm
G4 Atom
G4 RX