widebody
 

hey i was lookin around on here maybe last week and found a link to a site that had wide fenders for 200. does any one know where this was? i neglected to bookmark the page (big mistake) and i can't find it again. anything will help thanks!

I believe you're thinking of CorkSport's over fenders in the "Other" subcategory of the Styling category.

I thought I saw some side-fender panels at fc3s.orgs store.

They used to have an RX7 section, now its gone. Thats what it was under. It seems those guys care more about other types of cars now than the seven. I remember they used to have so much shit for the seven back in the summer, now it seems like most of it is gone and now its more of the other manufacturers of cars.
Maybe im not looking hard enough..

arent those widebody fenders always on ebay like 200? dont remeber, but they didnt look too bad from what i remeber.

Try www.raceonusa.com

/\/\/\ good stuff at raceonusa!
if you just buy the 3-point widebody fenders for the FC and no front bumper cover, you can get them pretty cheap, I think $500 or $600 shipped.

YES! this is was i was talkin about thank you! :D

so i have to get the wide body front bumper to fit w the wide front fenders?

That place sell a lot of stuff on ebay

They are really easy to deal with, send em an Email. waiting on my G4 Body Kit from them. (Getting it shipped to the office.)

nope, you dont need to get the front bumper lower half in order to run their widebody front fenders. it does make the entire install easier and more simple but it also adds cost, and I dont like how small the front bumper opening is for the radiator on their front bumper lower cover.

^ah ok thx. so i can just get 4 wide fenders and put them on and call it good? sounds good to me. i got a buddy at a body shop so i'll prolly do this after my engine :D

YAH, just get the 4 fenders if youre on the cheap.
the fronts might need some minor work to get the space at the door seam small and even, plus where they fit the hood mght need some sanding.
the rears are a lot work with a bonding agent or just use rivets.

You mean like this? (main site link from fc3s.org store, then click parts, then click FC3S.org parts)
http://www.speedmachineperformance.c...iber_parts?b=1