Sonar headlights with LED ?
 

Hello, I have installed LED bulbs into the Sonar lights; Will it be OK to mount the rubber boot in the back or will this cause any issues?

https://cimg8.ibsrv.net/gimg/www.rx7...88698c1aba.jpg
https://cimg9.ibsrv.net/gimg/www.rx7...0aa767d1b5.jpg
https://cimg1.ibsrv.net/gimg/www.rx7...402208e3e3.jpg

I'm asking if the housing of the bulb will get too hot and melt the rubber? Will it interfere with fan in the housing?

I guess this is a stupid question, that's why I'm not getting any replies!

the rubber seal will be fine to leave installed, as the fan will vent,

i think your bigger reason for not getting a response, is its not the right way to go about LED/HID install into these housings, as you are not using a projector retrofitted in.
as it still will be scattering the beam, you will still likely blinding oncoming traffic.

Thank you, I've been looking at a few threads on putting projectors in the housing.

From everything I've seen and read leds just don't output light in a projector correctly. The traditional reflective housing style is better for leds beam style.