PS2000 and IQ3 Logger dash problem
 

Haltech PS2000, latest firmware, CAN protocol set to Version2 in ECU Manager

connecting to Haltech IQ3 Logger dash (shows FW 19, tag on the back 1G12-2)

Datalink version 3.8.6

IQ3 connected on COM3, thru serial / USB adapter

following guide from http://haltech.com/wp-content/upload...gger_Guide.pdf

When trying to write to Vnet config downloaded from Haltech website, getting this error :

Programming device named : EFI Engine RPM
_CONNECT4_COMMAND:
32832 : 8040 5c a1 07 00

CCP ERRROR !!!
Internal timeout

Whent trying to read vnet config it stops after REBOOT COMMAND:
DISCONNECT COMMMAND:
Type 147 ID=501460
SEND ERROR !!!!
Template ID number expected

changing protocol to CAN v1 in Haltech ECU manager does not make any difference.

Sounds like a problem you may need to call or contact racepak with on their forum.

Is this a specific dash for the haltech ECU? Or the generic logger dash?

Its haltech logger dash, got it working somehow - atleast showing some of the values i needed, not tried all yet... looks like Haltech instructions are out of date.....