Need help with zero timing issue PS1K in FD
Here is the run down.
93 FD Fresh rebuild large street port Rotary works TB I'D2000 x4 MSD ls1 coils Running haltech platinum sport 1000. I got the car idling and cold start pretty much set for the time being. So here is the issues...... 1.) Car Only starts with the angle at 57 and tooth offset at 7. We can't start it with the timing locked at -20/0 or -5/15 like suggested. When we try to lock timing at idle car stalls. When we touch the angle or offset at idle car stalls. 2.) Can't get the gm 3bar map to read correctly. I set it to external then open folder in the map tab and selected the correct calibration but it reads -7/-8 vacuum and my AEM gauge reads -18 vacuum. I could really use some advice on the zero timing issue. Thanks, Doug |
Well I got the zero timing issue resolved....pretty sure I fixed the map sensor issue too.
Mod can close this thread out. Thanks |
2.5 hours and you nutted this one out for yourself,, well done - have fun !
|
Originally Posted by Boxer2rotary
(Post 10715885)
Well I got the zero timing issue resolved....pretty sure I fixed the map sensor issue too.
Mod can close this thread out. Thanks What was the problem? |
Originally Posted by t-von
(Post 10718081)
What was the problem?
Post the cure Dude! |
All times are GMT -5. The time now is 01:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands