Need help E11 ignition info. for 13B
Hi guys,
I need some wiring info. for hooking up the Ignition System for 13B operation, with respect to the Ignition Toggle, for using the Stock S4/5 Coils w/ignitors. From the Instruction manual for the Primary 34 Pin jack, it says that IGN3 (Pin #5, Yellow/Orange) is used for the Toggle function. But where exactly does this hook up to the Trailing Ignitor? Thanks spanner |
Originally Posted by spanner
Hi guys,
I need some wiring info. for hooking up the Ignition System for 13B operation, with respect to the Ignition Toggle, for using the Stock S4/5 Coils w/ignitors. From the Instruction manual for the Primary 34 Pin jack, it says that IGN3 (Pin #5, Yellow/Orange) is used for the Toggle function. But where exactly does this hook up to the Trailing Ignitor? Thanks spanner PIN 3....... Yellow/Black......Leading.... Green/Yellow PIN 4....... Yellow/Red........Trailing...... Blue/Yelllow PIN 5....... Yellow/Orange..Toggle....... Brown/Yellow |
E11 info
Originally Posted by crispeed
E-11 ECU....Haltech.................................Maz da
PIN 3....... Yellow/Black......Leading.... Green/Yellow PIN 4....... Yellow/Red........Trailing...... Blue/Yelllow PIN 5....... Yellow/Orange..Toggle....... Brown/Yellow Thanks a million dude, would be really nice for yuh to make a lil pass back in T&T sometime !! I'll send yuh a couple pics of my present project. Laterz |
Ok, the motor started up , but I find that the trigger angle had to be set to around 30 for the leading mark to line up with the pointer. I set the CAS with tooth offset of 3, as HItman's settings. Is this correct, or do I need to set over the CAS , in order to get a value closer to 65 +/- ?
|
For my E8 I have the trigger angle around 90-100 with a tooth offset of 9 IIRC. Thats with the mazda method as descibed on the Hitmans page.
|
FC's CAS for me is normally 60 deg trig angle with a tooth offset of 3.
To get that you have to realign the CAS from stock though. |
E11 Ign
Originally Posted by crispeed
(Post 6864183)
E-11 ECU....Haltech.................................Maz da
PIN 3....... Yellow/Black......Leading.... Green/Yellow PIN 4....... Yellow/Red........Trailing...... Blue/Yelllow PIN 5....... Yellow/Orange..Toggle....... Brown/Yellow Hi Crispeed,,,,, would these apply if I were to use individual MSD coils with DIS units?? or would you know which E11 outputs go to which plug,like IGN 1 to leading 1,IGN 2 to trailing 1 leading2 etc,etc. I want to replace my microtech with the E11 but I have been trying to find the ignition diagrams for my Turbo II,,, I am currently using 2 MSD DIS2,and 4 coils,,,,, with the microtech diagram I could see which wire goes to where, but I find it difficult for the haltech,because there is no specific diagram that I can follow. I am using 10 injectors staged, I figured that part already but I need some help on the IGN side. thanks in advance....... I searched the forum and the web but had no luck,Ive also emailed haltech,,, |
Ignition
1 Front leading Yellow/Black 2 Rear leading Yellow/Red 3 Front trailing Yellow/Orange 4 Rear trailing Yellow/Green |
All times are GMT -5. The time now is 07:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands