IGN-1A settings?
 

Like the title says, im upgrading from an FC ignition system that was setup like an FD, but now im going full crazy insane on the ignition.

What settings should i use? keep in mind, i have a FFE trigger kit, and a sport 2000.

TIP: if you switch settings make sure that your Coils are Disconnected Before doing so.Once you punch in the settings then hook them back up.
If not you will fry a Brand New coil.
My setup is close to yours.FFE Trigger,Plat1000 and IGN-1A coils.

what settings did you use?

I'm tuner illiterate.Sorry.
I had TheWird do it.
I'm lucky I know how to navigate my TV remote!
Pm Chris (C Ludwig).He can help you.he's a Haltech dealer.( Plug for Chris..yay Chris!!!)

Yeah, im hoping someone will chim in on this "hint hint" when they feel like getting around to it.

3. FC and LS1 Coils
Spark Mode Direct Fire
Constant Charge
Falling Edge
4-6mS (in direct fire mode)


i will assume that these settings are correct.

im gona be using the sprint re. do the new haltechs have variable dwell adjustability under different loads or is it just a one setting like the old e6k's? by what ive been researching, a 4.5ms dwell is about max to keep a long life for a coil (obviously depending on what coil you use).

another question i had is there a thread or writeup where they show all the different coils used and what mj they output at what dwell?

Just wanting to be sure that these settings are ok. ave not heard from anyone.

I'm using these settings for my exact setup aem smart coils and it works perfect

Ok cool. thanks a ton.

What are your power goals? Right now I am at 400 WHP and am using a dwell time of 4mS. This summer when I turn up the boost and go e-85 I will raise it up to 4.5mS. From what I have been told 4.5mS is about the max you want to run to keep the coils from overheating.

+1