|
Haltech ps1000 tps question
Ok I took a break from the install for a while cause I was getting burned out on it a bit and needed a break. I am almost done or so I think I am. Just have to wire the TPS and the wiring inside the car.
My question on the TPS. Which wires do I use. Its a s4 car (dont think It matters) but Im switching it to s5 TPS. TPS wire colors green/red black/red blue orange red yellow Haltech wires Orange white black Which wires connect to which wires. Thanks for the help I cant wait to finally finish this. By the way. A word of advice. have Ludwig make your harness. Wish I had. The harness has come out nice looking but it would have been much simpler to have him build it PNP. |
When you look into the connector on the TPS itself, so that you're facing the terminals and not the seals on the back, the pinout is:
TPS Signal - X- X 5V+ - Sensor GND - X So for a Haltech install it would look like this: W - X - X O - B/W - X The Xs are the three terminals that mate to the unused sensor. Make sense? |
Thanks I think it makes sense
|
Figured id revive an old thread for a question along the same lines instead of creating a new one. I am converting my UIM to an FD. Still using the same haltech wiring which wires do i need to retain on the FD TPS? Theres 4. I bought an adtermarket plug for it so the wire color on TPS side wont matter. just need the top to bottom pinout X X X X haltech Black/white/orange wire. Thanks |
| All times are GMT -5. The time now is 05:06 AM. |
© 2024 MH Sub I, LLC dba Internet Brands