Haltech boost control solinoid....
 

Just wanted to make sure I am reading it right....

By the 12V input on the picture that came with the solinoid...it said no polarity....

Which means it dosen't mater what pin goes where?

There are only two wires. PWM and a 12 V

Thanks!

James

sounds like it works the same way as a fuel injector. One pin gets constant power, the other is where the Haltech switches the ground on and off.

Didn't even think about it that way....good call:)

In fact....I uses a Bosch type fuel injector clip connector:)

James

DCV circuit dude...it doesn't matter which side is connected to power or ground.
I warned you the Haltech boost control SUX! :)


-Ted

I know man...you covered it in another thread....

But, I am gonna have try this one out for my self ;)

James