A/C into haltech E8
 

Manual states aux in and aux out is used.

Can't we just use a aux in and a PWM like the below information of the termination from my old setup on the e6k? Or what future setup would I miss if I did use the aux out. (I haven't use it yet)


1) Solder the Green Aux Input wire to the Blue/Orange wire(s) on the connector at the front bumper (by the relays and such)
2) Solder one of the PWM output wires to the Blue/White wire on that same connector (just above the blue/orange ones)
NOTE: Splice the Haltech wires in with the existing stock wires.
Do not remove the stock wiring from the picture.
3) Enable your Aux Input function in the Input/Outputs screen
4) Enable the chosen PWM feature, setup your RPM and Throttle postion to turn off the AC values, and set the Active Aux in to HIGH

Thanks,
Ian