BIG Problems After E6K Install
 

hey guys i finally got the motor, and haltech installed all the inside stuff wired. i plugged the laptop in and when i tried to go online it said RECONNECT HALTECH so i thought the plug maybe was not in or something, but it wasnt the case. so i checked all the normal stuff like battery connections and fuses etc. but to no avail. so we started checking lights and stuff inside the car and the radio wont turn on nor will the avc-r or A/F gauge.
heres the list that doesnt work:
turn signals (front)
logicon controls
wipers (rewired them)
starter (wont turn over)
CD player
AVC-R
A/F gauge
cruise control light (rewire it)

Heres what works:
brake lights
head lights and retractors
emergency flasher (back)
all the illumination lights inside including the logicon ones


Weird? i thought i had everything installed nicely and correctly. i am completly out of ideas here. i thought that it was weird that the Haltech was apparently not switched on. i attached the switched 12 volt using the grey wire on the flying lead to the front coil pack that is listed on the hitmans site.
other than that i'm stumped. thanks for you help
Jason

well after looking into the wiring to the haltech i decided to put the grey switched +12v to the +12v on the battery and it turned on. so i got online with the laptop and every sensor etc checked out fine.no problems. i just need to figure out why nothing happens when the ignition is switched to the accesory or to the on position. I am wondering if it has something to do with the taking out the old ecu/wiring harness. thanks
Jason

I know, old post.

Did you verify that you hooked up the correct wire for the ingition? On my site I have a wiring diagram of what wires to use. Usually it is an installation error when something doesn't work when first installing a Haltech.