Why pre-mix?
What does pre-mixing accomplish? How do I pre-mix? Are there any drawbacks to pre-mixing?
Sorry for the noob questions, but I've been wondering these ?'s for some time now. Brandon |
You might want to do a search for "pre-mix" because I am sure there are posts out there:)
Only pre-mix if you have no Oil Metering Pump, or Metering Oil Pump depending on who you ask:) If you want to pre-mix just dump in an ounce for a gallon of gas. Drawbacks? A little more to do at the gas station. |
I premix with Marvel Mystery Oil. It's supposed to reduce wear and help seal, but if anything, it's at least extra insurance and piece-of-mind.
Do a search. |
its also completely burns use 2 cycle oil for like outboard motors or go-carts or soemthign like that as with synthetic oil it does not completely burn during combustiong or soemthing like that??
|
|
I'm getting a new engine as we speak ... and when i saw the inside of my FD motor that had never had the joy of premix ... the need for it became abundantly clear. The OMP injects oil into the engine through a small hole. Well ... around the inside of the housing where that oil is injected was perfectly shiny and hardly any wear. it was about a centimeter wide ... with a centimeter on either side that didn't get the oil. On either side of the shiny stripe ... the housings wear carboned up and worn out. I can elaborate more on this ... just PM me.
In short, I'm going to premix on my new motor. There are several different premix oils you can choose from: Marvel Mystery Oil Mobil 1 MX4T Pettit Protek-R Klotz 50:1 2-stroke TC-W3 Hope this helps Van |
two-stroke oil burns in combustion better than most motor oils. and since the engine is lubed like a oil injection two-stroke but not useing two-stroke oil.
The 2-st oil is saposed to lubericate better than motor oil because this is what it was designed to do. Motor oil is not designed for rotarys and the closest thing to a oil designed for a rotary is 2-st oil. Make sense? |
Originally posted by Van Sema I'm getting a new engine as we speak ... and when i saw the inside of my FD motor that had never had the joy of premix ... the need for it became abundantly clear. The OMP injects oil into the engine through a small hole. Well ... around the inside of the housing where that oil is injected was perfectly shiny and hardly any wear. it was about a centimeter wide ... with a centimeter on either side that didn't get the oil. On either side of the shiny stripe ... the housings wear carboned up and worn out. I can elaborate more on this ... just PM me. In short, I'm going to premix on my new motor. There are several different premix oils you can choose from: Marvel Mystery Oil Mobil 1 MX4T Pettit Protek-R Klotz 50:1 2-stroke TC-W3 Hope this helps Van |
All times are GMT -5. The time now is 07:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands