rotary weight???
dose any one know how much a rotary engine weighs?
|
Be more specific, they are not all the same.
|
13B NA with a T78 and 5 speed tranny :)
yay, 400th post :) |
The answer is 42.
Really dude... I mean, there are over 15 different types of rotaries out there, not counting different variations of them! I assume from your screen name you mean a Series 5 FC motor? N/A or Turbo? Shortblock or fully assembled long block? SPECIFICS NEEDED!!! |
Originally Posted by poor_red_neck
I assume from your screen name you mean a Series 5 FC motor? N/A or Turbo? Shortblock or fully assembled long block?
The simplest method is to start with the weight of a 12a and 13b longblock in N/A stock trim. From there you can add in the weight of the turbos, which is fairly close among all cars and applications. Same goes for headers and such too. For those inclined to tinker, we can start with the weight of the shortblocks and then add on the weights of the specific intakes, carbs, headers, water pumps, alternators, etc.. Once again the weights of a lot of the accessories are going to be the same among most makes and models. |
well i ment to say the 91 turbo 2 engine and the 3rotor of the JDM eunos cosmo sedan during the 1990s
|
I like how this didnt get answered at all. How much does each engine weigh, intake to exhaust manifold? Talking like 12a, 13b s4 (turbo), 13bs5(turbo), 13b-rew turboed, 20b.
|
Originally Posted by sar
I like how this didnt get answered at all.
|
well, the 4 port 13B in my repu(not origional, its something out of the 80s), was pretty heavy, but it was not heavy enough that i couldn't pick it up off the ground, and put it in the trunk of my car a few feet up... it was a short block tho
|
Did you guys all just want to yammer or do ne of you know the weights of ne of the rotary engines? Is there a place to look up this info, I'd assume there is. I remember someone in here saying a LS-1 didn't weigh much more than a 13b and I thought that was complete bs but I have no idea what the 13b weighs except that u can pick it up urself.
|
lets start with how much do the different rotors and housings weigh?
|
This info is only semi-accurate, so it shouldn't be taken as fact.
13B 22 '74 13B carb and intake manifold 27.5 front plate Y 29 intermediate R5 34.5 rear plate Y 11.5 rotor 11.5 rotor 14 rotor housing 14 rotor housing 15.5 13B E shaft 33 flywheel (without P plate or clutch) I'd estimate the tension bolts are about 5 or 6 LBS, but I could be wrong. 218.5 total without waterpump, alternator, P plate or clutch |
You fucking rock Jeff.
Whoah, so I weigh almost as much as my engine. But I'm not putting out nearly that much hp. |
All times are GMT -5. The time now is 02:36 PM. |
© 2024 MH Sub I, LLC dba Internet Brands