orbital sanding to the side plates.
anyone out there has run an orbital sander on the side plates to clean them up a bit and give the surface a "honed" feel?
|
no one has dared?
|
plenty of people do / have done it ..not everyone has deep pockects or a handy machine shop down the road
... or even maybe one that can achieve the correct surface texture -------------- be careful to be fairly consistant with the power tool across the entire plate and its edges also- a much better finish is achieved when you do a final step of adding cutting paste ( treflex) and rubbing two plates together in a figure 8 motion this can be very time consuming - be aware that using something with alum oxide abrasive ( paper and cutting paste ) needs to be thoroughly wiped and washed before use here is one i prepared earlier - http://i1117.photobucket.com/albums/...ebuld/MYBP.jpg |
^ very nice!
|
All times are GMT -5. The time now is 01:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands