installing apex seals with broken end piece
I had to take me newly built engine (13B-REW) apart again after I found a small water leak.
It turned out to be a pinched outher water seal bewteenw front rotor housing and center plate. I also found all my apex seals with broken end pieces (I turned the engine a few times to check compression). I know that putting them back in will be a pain in the ass, so any tip would be greatly appreciated. Many thanks in advance, |
super glue the seals.
|
degrease the seals, super glue them, let it take a set. after it dries, use a razor blade to scrape away the excess glue that bled out the sides, otherwise you'll have issues with the apex seal binding on the corner seal during install.
|
sweet, thanks a lot guys... what would I do without this board:D
|
it happens to me on my last build,i didnt scrape away the excess glue and what a pain in the ass to to get them in place,being a HB motor(installing seals with the small piece facing the center iron)didnt help at all neither
|
All times are GMT -5. The time now is 02:51 AM. |
© 2024 MH Sub I, LLC dba Internet Brands