help 13bt wont rev
Hi
Help needed I am running a 1x13bt stock std 1xMicrotec mtx-8 managment system 4x coils std boost .3bar 4x new plugs 1x new program on mtx-8 Swopped out new coils, cords etc problem :eek: she will not go over 6k when you drive :confused: but yet if you stand in neutral and rev her she gets 8k revlimit :( Whats up any ideas on this please give your input TIA |
have the motor checked for compression, both HOT and COLD.
is the management system setup for linear injector control or staged? |
its it too lean/running out of fuel? what happens at 6k? does it pop, or make any noises?
mike |
make sure its breathing properly...intake&exhaust...no restrictions.....
|
Originally posted by diabolical1 have the motor checked for compression, both HOT and COLD. is the management system setup for linear injector control or staged? |
No noise just feels like you drive into a brick wall or 2
and its not the same as hitting a rev limit either just a total loss of power at 6K in any gear tested fuel pressure ,compresion only on cold the back yard way :D spark etc As for the program setup its on the base map from Microtec with no changes this setup works fine in another 13BT swopped the computers around solderd all the connections As for fueling she is a tad rich on idle(12.?) "sounds like a mild bridge port" and then seems to go to +- 13.7 from 3k-4k and then from 5k to wall 12.? again exhaust was a tad small would not boost more than .3bar now i can push 1.3 after the change from 48 to 63 induction is 58 from cone filter to turbo inlet |
I had the same problem and it turned out to be a clogged cat. Try disconnecting you cat and running the car around the block. If the powers back, thats it.
|
how is your timing?
mike |
All times are GMT -5. The time now is 08:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands