frankenstein 13brew motor questions
hey all, just had a few questions regarding my FD's new motor setup:
- 13b w/ 8.5:1 FC rotors, FC front counterweight and a RX8 e-shaft. I am using the smaller (FC sized) thrust washers/bearings etc to match up with the counterweight. Question #1: I am using an e-shaft bolt from a RX8, is this ok? Or should I be using a FD bolt? Thread pitch is the same, both have a groove for an o-ring but the RX8 bolt seems longer. #2: Is it acceptable to use the RX8 bolt with a FD front main pulley? Or will I need to switch over to a RX8 pulley? I believe it should be ok to use the RX8 bolt w/ the FD pulley, FC counterweight & washers/bearings but just wanted to double check. Endplay with this assembly seems good (.0020in). Thanks in advance! |
I'm using an FC bolt on my RX-8 e-shaft and FC pulley. it works fine. An RX-8 bolt should be fine
|
All times are GMT -5. The time now is 04:55 PM. |
© 2024 MH Sub I, LLC dba Internet Brands