Identify Center Housing
#1
Identify Center Housing
Looking for some help identifying an iron the I recently bought as a package for a short 3 rotor. Was told it was an S5 center housing, I'm assuming its an NA housing. Looking at doing a semi PP so would like to match center irons with this modified one.
#2
rotorhole
looks to be an n5 n/a but the pics aren't of the best angles to tell. the only thing i can see is the tension bolt is encased under the exhaust port, which means it is an S5 housing, either turbo or non turbo. doesn't appear to have EGR ports in the intake either.
pretty certain both turbo and non turbo center irons have the same port timing, so either should work.
pretty certain both turbo and non turbo center irons have the same port timing, so either should work.
#6
rotorhole
definitely is a non turbo since there is no thread for the intake manifold.
definitely is a series 5 iron with the tension bolt support
i just couldn't tell you if there is any difference in irons overseas versus our USDM ones.
definitely is a series 5 iron with the tension bolt support
i just couldn't tell you if there is any difference in irons overseas versus our USDM ones.
Thread
Thread Starter
Forum
Replies
Last Post
hurleysurf24
2nd Generation Specific (1986-1992)
2
10-18-07 12:34 AM
79+80_rx-7
1st Generation Specific (1979-1985)
8
02-23-02 10:44 PM