What is the drive ratio, metering oil pump : eccentric shaft?
#1
Full Member
Thread Starter
What is the drive ratio, metering oil pump : eccentric shaft?
Hello people!
can anybody tell me what the ratio is between metering oil pump’s rpm and eccentric shaft rpm?
for example, 1:2 — one turn of the MOP for two turns of the e-shaft?
can anybody tell me what the ratio is between metering oil pump’s rpm and eccentric shaft rpm?
for example, 1:2 — one turn of the MOP for two turns of the e-shaft?
#2
Old [Sch|F]ool
I never checked, but since it is driven off of the same semi-worm gear that drives the distributor, geometrically it probably turns at half eccentric shaft speed.
I vaguely remember the gear being the same diameter as the distributor, as well. I never checked, as I generally chuck all that stuff and plug off the oil hole in the front end housing.
I vaguely remember the gear being the same diameter as the distributor, as well. I never checked, as I generally chuck all that stuff and plug off the oil hole in the front end housing.
Thread
Thread Starter
Forum
Replies
Last Post
IAN
General Rotary Tech Support
2
01-03-10 02:42 PM
M104-AMG
3rd Generation Specific (1993-2002)
9
07-13-07 03:04 PM
nipplebandit45
1st Generation Specific (1979-1985)
12
03-04-02 11:23 PM