Bosch/RC/ID injectors
 

Guy's I am looking to downsize my current Bosch EV1 1600cc primaries for some 1000cc units.
There are a number of options I have seen. most common being the Bosch EV14, ID1000's and RC Engineering 1000cc, also Grams and Deucthwerks which I have not heard of.

The RC ones look the same as my Bosch so should be a straight swap in replacement and are also Low impedance if this is something I need to consider with my microtech LTX-12?
The other option I am really considering is the ID1000's which I see come supplied as a kit which I think but am not 100% sure should drop in with my current rail and spacer setup? They are high impedance though if this is an issue.
I will keep my current Bosch EV1's as secondaries. So not sure if you can mix and match high and low impedance?

Mainly I was after advice and opinions on which to go for or any other option I may not have considered? I heard a rumour RC were a bit unreliable but nothing to back it up?

Thank you
Lee

No feedback on this from anyone?

You will definitely want high impedance for primary injectors.

ID injectors do come as a kit but you need to tell them what you need for them to provide with the right pcs.

You can go with ev14's to save a little money. I'd just call IRperformance and tell them what you have and they will take care of you. Very helpful and reasonably priced.

Thanks for feedback.. I am UK based but will look them up.. I may have already contacted them I fact. I have family over in the US at present so could buy either side of the pond! Point taken on high impedance.
I found Deka (siemens) injectors yesterday.
These look identical to the ID ones, spec reads the same but they are a fair bit cheaper. I assume being Siemens OEM's will use them so they should be good and reliable? interested to get feedback though.

Thanks
Lee

what are you dropping these injectors onto?
You never mentioned any series of car or engine.

20B powered FD3 with Microtech LTX-12 ECU.

Thank you
Lee