https://www.rx7club.com/ Area is for discussing Haltechs en Thu, 21 May 2026 18:38:17 GMT vBulletin 60 https://www.rx7club.com/images/misc/rss.jpg https://www.rx7club.com/ https://www.rx7club.com/haltech-forum-62/elite-2500-injector-dead-times-1173233/ Sun, 10 May 2026 04:47:20 GMT So Im trying to figure out how to get the correct dead times for injectors. I am running the ID725 injectors and when their spreadsheet info is added I have higher then normal VE numbers, close to 70... So Im trying to figure out how to get the correct dead times for injectors. I am running the ID725 injectors and when their spreadsheet info is added I have higher then normal VE numbers, close to 70 at idle and up to 142 under boost. What is the proper way to get the dead times right so that I can get my idle VE closer to 50-55? I have been told to set 55 in the base table in idle range and then page up the dead times until I get to the AFR I'm looking for (13.7). Is this proper or is there a better route to do this? I have confirmed everything else is correct like base fuel pressure (52psi) and all sensors has been correctly set. Most are the haltech sensors and then there is the fast reacting air temp that I got the calibration from Ludwig. Timing is spot on with the FFE hall trigger wheel. Any help is greatly appreciated. ]]> Haltech Forum Zatzy https://www.rx7club.com/haltech-forum-62/elite-2500-injector-dead-times-1173233/ https://www.rx7club.com/haltech-forum-62/%9186-fc3s-n-getting-swapped-%9190-tii-need-new-harness-1173088/ Thu, 23 Apr 2026 19:21:26 GMT Need advice on a good ecu + harness. I would like to run an Elite 1500 since it seems like it has the best support in terms of sensors and things of that nature. I don’t have a harness currently, and... Need advice on a good ecu + harness. I would like to run an Elite 1500 since it seems like it has the best support in terms of sensors and things of that nature. I don’t have a harness currently, and I’m honestly not too fond on running a 40 yr old harnesss for a big street port tII. However I can’t seem to find anywhere that sells harnesses for tII motors that plug and play with the elite 1500 or any ecus to be frank. I know there are tons of people who know way more than I do on here, please help lol ]]> Haltech Forum Bliff.fc https://www.rx7club.com/haltech-forum-62/%9186-fc3s-n-getting-swapped-%9190-tii-need-new-harness-1173088/