Autronic SM2 Tuning
 

does anyone here use/seen/tuned an autronic sm2 setup on a single turbo rotary? if so, i was just looking for some tuning advice or opinions.

I only use the SMC at the moment, on my new project I am going to use an SM2. The set ups are the same similar. Only difference being you can configure different igniton channels (for split)

I can maybe help you if you need some advice or something?

There are other difference's as well not just ignition set up, anyway.

If you send me a copy of your .cal file that currently is in your ECU and a full list of mods, I will look over it for you if you like?

riceracing@ozemail.com.au

I have one of those piece of crap SM2's for sale if anyone wants it cheap!

Jason.

too bad you dont have one of those plug and play AEM computers for the FD for sale, huh Jason :)

BTW, can you give me the part #'s for those bosch COP coils you use again? do you know where i can buy 4, and about how much they cost?

Thanx
Roan

Well when your piece of crap has achieved 1/10th of the race victories around the world on circuits from Pikes Peak to Bathurst I may consider buying it :D

Send me an e-mail on how much you want for the SM2 and I will take it of your hands if the price is right riceracing@ozemail.com.au

HEY MATE.
I HAVE DONE A COUPLE OF SM2 SET UPS IN THE PAST.I HAVE THE PROGRAMS SO IF YOU PM ME WITH THE DETAILS OF YOUR SET UP I SHOULD BE ABLE TO GIVE YOU SOMETHING PRETTY CLOSE AND GET YOU UP AND RUNNING IN NO TIME.
JON
RX ENGINEERING

How much?!?!?



-Ted

Hey Jon, turn off your caps lock key ;)

So Peter!
The new SM-2 can do split timing? What about staged injection?
SM-2 with the 4-bar map sensor combine with their wideband might just be what I'm looking for!:)

crispeed
87 Rx-7 TII
9.204@150.47mph
2600lbs
Un-tubbed

RICE RACING GROW UP
 

Post deleted due to lack of content and manners. Check your PM for details. - Evil Aviator

Hey Black680hp7, I'll take that SM2 off your hands!&nbsp Do I need to PM you?

Hey RXE13B can't you read the other post that says to cut the flaming crap out of this section?&nbsp I'd vote to ban this loser cause he can't read instructions!



-Ted

Black680hp7 where are you? You want to well that piece of crap (as you call it) or what?

Rice and Ted, e-mail 680hpFD (Jason) i dont think he's keeping up with this thread. i sent him an e-mail about the COP set-up and got a reply the same day....

Yeah, I did that a few days ago with no replies.&nbsp I'd figure he's getting a lot of mail on here due to his unique position at AEM.

I need the SM2 for an SR20DET swap. :D

Thanx SPEED_NYC for the heads-up!



-Ted