|
can you post pics of the knuckles if you don't mind?
also if you have a newer rubber tie rod boot you can slip it towards the inner ball joint which will give you throw before the boot max's out.. |
Originally Posted by jawbreaker
(Post 11599319)
I know this thread is hella old but I supposedly have these knuckles on my car... The problem is with the extra travel the rack boot pops off of the rack.is there a certain boot that'll work with this?
|
Just by this thread I would go with JTPs knuckles, he is obviously easy to get a hold of and very stand up guy. 100$ now could save so much trouble later
I just realized how old the OP is.. haha my bad |
|
12 Attachment(s)
Pics of my install
Attachment 644962 Attachment 644963 JTP/stock Attachment 644964 Mazdatrix/stock Attachment 644965 Installed Attachment 644966 Attachment 644967 Wheels off Attachment 644968 Hitting lower caliper bolt against control arm Attachment 644969 Wheels on Stock Attachment 644970 Attachment 644971 After Attachment 644972 Attachment 644973 |
4 Attachment(s)
Alignment
First I had to recenter the rack making sure from center it's 1 1/2 turns left and right. Then remove/reinstall steering wheel so it's straight and adjust tie rods. In order to get a 0 toe angle I cut off 1/4 from each end of the inner tie rod. Before tie rod cut (toe maxed out) Attachment 644958 After Attachment 644959 Attachment 644960 Attachment 644961 |
| All times are GMT -5. The time now is 08:07 AM. |
© 2026 MH Sub I, LLC dba Internet Brands