my 85 daily has some issues
 

Hi My Name Is Chuck I Just Got An 85 Rx7 And I'm Having A Few Issues With It First Off My Omp Is Not Hooked Up At All I'm Currently Using A PremixBut Id Like It To Be HookEd Up So AnyHelp With That Would Be Appreciated Also I'm Looking For A GasTank For It And I'm Having Trouble Finding One I Was Wondering If An Fd Tank Would Fit Since I Also Have A Project 93 I'm Not Using That Tank In It So I'm Curious About Fitment Also Its Not Letting Me Upload Pics In The Thread So I've Upload Some To My Gallery And If You Need Other Pics To Help I Can Upload Them There Thanks

Hi and welcome. To hook up your metering pump ( I assume you have a 12a car) you need a rod that goes from the pump itself to a lever on the carb. This lever is closest to the front of the car on the carb and is accessable from the pass side front. A few fine washers and cotter pins is all that holds it to the pump and carb. As for your gas tank issue I would keep your eye on the for sale section on this forum. Tanks come up for sale in part outs etc from time to time. Be ready to spend a little money because you are not alone in your quest for a good gas tank and there are others who will scoop it out from under you lol. You also might consider a fuel cell like what Summit racing sells. The only drawback is fitment and usually loss of your spare wheel well. Hope this helps. Good luck

Yes It Is A 12A Car And Thanks It Does Help A Little I'm Mainly WonderingHow To Hook Up The Oil Lines I Was Told Id Have To Drill Holes Into My Air Filter Base But Thee Carb Is An Edelbrock 1406 It Has Vacuum Ports On It BuT I'm Not Sure If I Can Hook The Lines Up There Or Not And AsFor The Gas Tank I'm Going To See If The Fd Tank I Have Fits This Weekend I'll Keep Updated On This As I'm Sure It May Help In Other Peoples Searches

Well Sadly The Fd Tank Will Not Directly Fit In The Fb But It Was Worth A Shot AndNowThat My Tank Is Sealed I'm On To Hooking Up The Omp To My Carb The Linkage I Can Work Out But The Oil Lines I'm Going To Have To Extend ToWhat I Think IsWhere They Should Be Connected I Uploaded A Pic Of The Carb In My Gallery There's 2 Vacuum Ports On The Bottom Of MY Carb On Either Aside Of The Pcv Port Under The Mixture Screws My Question Now Is Is That WHere I Can Hook The Lines Up To?

You may have to drill holes going into the primary venturis and tap vacuum ports into the holes. Then connect the OMP lines to those fittings. Suction from the engines vacuum does the rest. Youll know you did it right if you can see oil sucking down the venturis while revving at idle with the air filter off. Simply drilling into the air filter will not have enough vacuum to suck the oil through. Tapping into a standard vacuum line will give inconstant amounts of oil.

Also I believe only 81-85 tanks with 12a will fit your car properly.

this Actually Helps Alot Thanks as Far As The Tank Goes I Used Windshield Glue To Seal It And Its Working For Right Now Is Actually BeenLike That For A While But I'm Hoping I Can Get A New Tank At Some Point