1st generation 20b swap project
5 Attachment(s)
Working swaping engine from 12a to 20b.Painting the inside of the car.
|
Nice..... I'll race you!!!:icon_tup:
|
What did you do in terms of engine mounts? Did you fab up something original or do a conversion from a FC or FD subframe? I am very interested in what you did since I am planning on doing a GSL-SE to 20B conversion in the near future...
|
You have to tell us your motor mount solution.
|
dose it run yet?
|
I used the 12a motor mount dut i modify ill should you some pic tomorrow it still not running.
|
when its running make avideo plz
|
Looking good man. Id love to put a weber carbed 20b built within an inch of its life in my car some day
|
Originally Posted by lomber13
(Post 9514252)
I used the 12a motor mount dut i modify ill should you some pic tomorrow it still not running.
|
where did you get the motor?
|
In clifton nj
|
4 Attachment(s)
Here is the motor mount
|
great job,what are you gonna do for turbo setup? Stock by the looks of it.
|
Stock for now. Later will see what we do!
|
what tranny did you use?
|
Did you cut out the center section of the cross member to make clearance for the oil pan then bolt a lower cross piece into the cutout section?
|
Yes we cut the cross member to make clearance and modify the oil pan.
|
i would love to have that motor in my rx7 then i can race my friends B20 powered civic.
|
3 Attachment(s)
More pic of what are we doing
|
When you said modify the oil pan, i thought you may have just meant with a hammer or something... It looks like you fabbed up a completely custom oil pan from the looks of it. What transmission did you use?
|
1 Attachment(s)
Dam Alex you guys have been doing some nice fad to your 1 gen. Save some energy for my 3rd gen. I may stop by the shop tomorrow to change my fuel pump. Here is an outside shot of your car :icon_tup:
|
Im using a transmission of a 13b turbo 2
|
whats up alex any new pics
|
i can't wait to see this thing running. what engine management are you planning to use?
|
That is something we are working right at this moment, I have the original dot is give me problem to get the right wire where they go.
|
All times are GMT -5. The time now is 08:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands