What PSI should I start to spray?
I have a na aquamist 2d which has a preprogrammed map , I have it setup so it starts spraying at around 5psi .
my max boost is 13psi . now I've been reading and I did notice my a/f has richened from 11 to 10's after the install of my meth kit so I've been reading on leaning it out a little bit to make some more power instead of lose power . I'm running windshield washer fluid . which btw I think the ones htat work in colder temps are better correct? but people keep telling me I have it set to early I should have it turn on much later . BUT I dont think they understand that my setup has a map its not just one of those on / off meth systems . rather then listen I've tried searching but failed at my criteria picking . so I'm just wondering if anyone has any advice in this reguard. as for the nozel.. I honestly dont know my kit was used , and had only one nozel . with no markings |
I've heard, industrial methanol is better choice... Some people made more power with it vs windshield fluid. Search about it.
|
5 psi is good I think
|
Originally Posted by tom94RX-7
(Post 11096172)
5 psi is good I think
B |
Originally Posted by BDC
(Post 11096476)
+1. Earlier in boost the better IMO but don't go too heavy on it. Can reduce EGT's too much if using too much and can lower boost threshold.
B |
Originally Posted by Tem120
(Post 11107711)
THe max my system will spurt out with the biggest nozzle is only 300 CC's I've left it at 5 psi and it seems to work fine there .
|
i have mine kick on at 8psi
|
All times are GMT -5. The time now is 11:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands