My cooling mist kit installed pics
 

I made the mount for the pump from 1/8" aluminum. I had some pieces left over from something else and they were just the right sizes. Barely any trimming needed to be done. Its bolted directy to the floor. The reservoir is the stock washer fluid holder from my other FC for the rear wiper. I was going to put it in the stock location. but it sat lower than the pump, and i didnt like that. so i mounted it there on the speaker tower. makes it easier to refill and see the level also. I ran the lines up through the center of the car (inside) and im injecting into the stock top mount intercooler. I'll have pics of that later on.

also, the reservoir is low enough so i can make or buy a cover to hide the fuel cell the AI stuff. the car is basically stock in the motor area. Just intake and exhaust. So i wanna keep the stock look going, but a fuel cell and AI pump take the stock look away. lol... so they will be hidden.

I used the lines that came with the kit fo the 50/50 water meth mix. and a 1/4" polypro line from home depot for the boost switch. its a hard line just tlike the black one from cooling mist. got a huge roll for 2 bucks.

http://i282.photobucket.com/albums/k.../AIinstall.jpg

http://i282.photobucket.com/albums/k...AIinstallb.jpg

http://i282.photobucket.com/albums/k...linstalled.jpg