AEM WI Install Tests
 

AEM 315 Nozzel Flow Test

The AEM adjustents screws are small and are not very accurate.
I used an accurate gauge to adjust the low pressure turn on points
and the 16psi target boost value. The max value was by the values on the controller.

Test1: Low Setting = 5psi, High Setting = 38psi, Boost = 16psi, Flow = 360 ccm/m
Test2:----------------10----------------------21---------------16-------------390
Test3:----------------10----------------------27---------------16-------------375
Test4:----------------10----------------------33---------------16-------------300
Test5:----------------10----------------------38---------------16-------------290

Deductions from tests:
(1) As you set "turn on boost" lower, the target boost WI rate increases.
Or set it higher and target boost WI rate decreases.
(2) As you set "max boost" lower/closer to target boost, WI rate increases.
Or set it higher and WI decreases.