Does anyone have this? AEM wideband
http://www.rx7store.net/index.asp?Pa...ROD&ProdID=814
I like it because it can fit where I currently have the narrowband A/F guage and does not take much room elsewhere. |
I have It. As of now I have It boxed up and will be replaced with my narrow band A/F Ratio Guage. I like how It Is offered with an adjustable calabration output.
|
they are cool, but suposedly only read to 11.0 A/F and below that, go OL "offline"
|
I understand It reads below 11.0 A/F *when datalogging* - but does not not display this on the actual Guage.
|
That is correct. The gauge is limited to 11 to 17 I believe but the sensor reads a wide range which can be displayed or logged with your EMS or PC.
|
I have the older non-gauge type and it's been totally useless up to this point. Apparently it does not interface well with the datalogit, causing lots of noise and poviding a useless signal. I'm not the only one to experience this. I think if you use it with the AEM EMS you'll probably be ok, but if you're buying it for a PFC/datalogit, you may want to look elsewhere. Here's a thread I started on the AEM forum that basically went nowhere other than confirming that others have the same problem.......
http://forum.aempower.com/bbs/viewto...?p=55651#55651 There's also several others on the datalogit forum with my same woes... Between the problems with the AEM CDI and the AEM UEGO, I think I'm fniished with AEM.... |
All times are GMT -5. The time now is 12:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands