AEM + OZ DIY WB Interface question
 

Hey All,
I finally got the 2nd bung in the SSDP and finished the OZ DIY WB Kit. Has anyone installed this combination?
I have a few questions.
1. What did you use for wiring between the OZ and the O2 sensor? wire guage, shielding, length?
2. Where did you mount the controller box?
3. Do you have a drawing of how to interface the input to the AEM?
4. Can I just break out the Vout wire and plug it into the original harness input from the stock O2 sensor?
5. Have you had any problems with low voltage with lights or heater on effecting the operation?
6. Did you have to calibrate the input from the O2 Sensor to the AEM?
7. Are you using the auto tune function? About how long did it take with street driving to tune it?
Anything else you can pass along that would be of value ?

Please try and keep the conversation to facts you know to be true from real life expirence and not what you think to be true or what someone told you or you read someplace. I was hoping to keep the information clean so it was easy to follow.

Thank you very much fo any info you can share.:eek: