sake bomb garage ignition coil harness with apatronic ecu question
 

I have a sake bomb garage direct fire coil setup. i'm Going to start using an adaptronic ecu with the internal map sensor.
The thing is with the sake bomb harness one of the wires is splice into the stock map sensor middle wire{black/green stripe}. I forgot what the wire exactly does.
Since i'm not going to be using the map sensor anymore where would I splice that wire into now?

Thread copied to the adaptronic ECU section.(Engine management section)
Good luck to ya.

I believe you are still going to splice into this OEM map sensor wire per their instructions. Do you have a diagram from this ignition kit?

Just because you are switching to the OEM internal 4 bar map sensor does not mean any of the wires going to the OEM map sensor are being deleted.

I don't have the instruction diagram anymore. I forgot what that wire actually does. I know the wires aren't being deleted. I wasn't sure since the map sensor wont be plugged in anymore, if it was still going to send the signal I needed in order to make the direct fire ignition work.

so I guess the question is even if the the map sensor isnt plugged in will I still get the same signal as if it were plugged in, or do I have to find a different source for the wire that is spliced in?

emailed sake bomb still waiting for a response.
it looks like they have an updated harness on their website because when I download the instructions it doesn't even mention that wire. their new harness doesn't even have it.

Even with no map sensor, and the ECU set to internal map sensor you will be fine.

sounds good thanks