| Turblown |
11-04-16 10:01 PM |
Rob Dahm's AWD 4 rotor to run the M6000 Modular ECU
1 Attachment(s)
In the rare event one has not seen it, Rob's AWD 4 rotor is running the new Modular M6000 ECU. The ecu will also be controlling the pneumatically paddle shifted Hollinger RD6 tranny. Traction control, launch control, boost by gear, dual maps etc will all be setup. The car is geared to do 250MPH which Rob intends to do at Bonneville. The car will be going into wind tunnel testing after the engine dyno, and completion of the car. That target for completion is March. The car is also going to do Pike's Peak, 1/2 mile and Texas mile, in addition to being driven on the street with pump gas. Race gas for the higher boost stuff.
|
