Fresh rebuild adaptronic issues
Having some issues getting my car to start for the first time on the new rebuild with the freshly acquired Adaptronic modular in my FD. Engine was basically a stock rebuild with the ports cleaned up a little, but no street port or bridge port. Running an aeromotive FPR with a fuel pressure sensor and an oil pressure sensor. I have the adaptronic basemap on for the s6 loaded up and so far have not been able to get it to start. I used the scope and It is hitting all 360 and -360 degrees but cranking rpm is only reading 1rpm, and thats with a brand new starter and fresh odyssey battery with a jump pack hooked up to the car for some extra power. Other mods include a full exhaust system, non sequential turbos, banzai pulley kit with air pump and ac deleted, and apexi intakes. I am also running an innovate wideband and innovate boost gauge. I'm really trying to get this thing to start so i can give it a once over so I dont have to waste anyones time with the break in tune to make their life easier, but at this point I'm lost. Any insight?
|