Constant fuel prime
 

This one is my fault. Pump runs constantly after I installed power straight to the fuel pump via a relay. Please see below attached diagram of how I installed it. I may be missing something here:) NO idea why the image is upside down LOL.

Did you try this? I ran my relay triggered by the stock Fuel Pump wire, then put the jumper wire in up front to make it run whenever the key is on, but Adaptronic has a little thing about it in their pinout to get it to run from the ECU...see below.

3D
Blk / Red Starter inhibit
Aux Output 5

To drive the fuel pump from the ECU, required if you are going to remove the airflow meter, cut this wire, and connect the Blk / Red wire from the ECU to the brown wire on the airflow meter connector.

Thanks PinkRacer. I think I have it set up that way. The constant prime was not on until I wired the fuel pump to the battery via the relay as shown in my previous attached picture.