adaptronic split timing
 

On the software when i change the units to psi, on the timing split table it still shows kpa, also adaptronic mentioned something about adding more resolution for negative split is that coming soon?

I'll check out why it shows kPa instead of PSI - it should change the same as the other displays.

That table will do negative split - making the tables have arbitrary spacing is fairly high on the list so I'd say about a month - 2 months away. Thanks!

I have the same issue in the software as it still show kpa instaed of psi in split timing table.

Thank you Andy

The numbers do switch to psi setting,
looks like only the letters are stuck at kpa

Got mine fired up, have been very busy,
very little time to work on the car, hope to finish her up next fe days

I don't quite get the intake manifold setup; do you just have a hose going into primary runner? Or does that plate form a really little plenum?

Congrats on getting it wired in and fired :)

Attachment 494591

Its a test plate, with vacum hose on primary runner for the map sensor :)

Thanks Andy

Ah I see, and those holes are your throttle :) Never done that or seen it before! Cheers :)