RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   wiring my jdm swap (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/wiring-my-jdm-swap-946788/)

dj-fd3s 03-21-11 11:25 AM
wiring my jdm swap
 
Let me start by saying that my p.c. Is down so it made it hard to look this up as i think its some where on this site. Ok I have a 93 that I'm installing a j spec engine in an I found that the wire harness is different not much but it is different. Is there a jumper harness I can buy or do I have to swap harness from one to the other or can I rewire it so I don't have to rip up the rats nest

shetlen 06-30-11 02:04 PM
bump, I was wondering the same thing.

Mahjik 06-30-11 02:13 PM
Originally Posted by dj-fd3s (Post 10528161)
Is there a jumper harness I can buy or do I have to swap harness from one to the other or can I rewire it so I don't have to rip up the rats nest
No jumper harness. If you are using a NA ecu, it's easier to use a NA emissions harness. It's not that difficult to swap the emissions harness if you've already installed the engine.


All times are GMT -5. The time now is 04:05 PM.


© 2024 MH Sub I, LLC dba Internet Brands