RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   3rd Generation Specific (1993-2002) (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/)
-   -   Why a boost controller? (https://www.rx7club.com/3rd-generation-specific-1993-2002-16/why-boost-controller-418913/)

RotorFrank Apr 24, 2005 09:00 PM

Why a boost controller?
 
I was wondering this, if you have a Power FC, then why get a boost controller. Isnt that controlled by the PFC? How does it work exactly?

rx7girlTK Apr 24, 2005 09:04 PM

i would say because the pfc boost controller is only controlled through the ecu...as with a boost controller it is mechanically controlled

WanKeL FD RX-7 Apr 24, 2005 09:05 PM

because, every fd is different, some are able to control boost with the pfc and other that aren't able.

Getting a seperate boost controller is much more accurate.

Max

RotorFrank Apr 24, 2005 09:13 PM

But what happens when the PFC is set to throw out .90 bar and your boost controller is higher? Dont they act against each other? or does the boost controller take over since he lets threw more air from the turbos?

cloead Apr 24, 2005 09:29 PM


Originally Posted by RotorFrank
But what happens when the PFC is set to throw out .90 bar and your boost controller is higher? Dont they act against each other? or does the boost controller take over since he lets threw more air from the turbos?

When you hook up manual boost controllers with a PFC, you disconnect the vacuum lines going to the wastegate and prespool solenoids, therefore the PFC no longer can control boost.

And if you have the pfc boost set at .9 bar, and your boost controllers set higher, the PFC will cut power to keep you under .9 bar.

alberto_mg Apr 24, 2005 10:09 PM

generally the PFC boost would be higher and the boost controller would control boost up to the level you specify.

cloead Apr 24, 2005 10:18 PM


Originally Posted by alberto_mg
generally the PFC boost would be higher and the boost controller would control boost up to the level you specify.

Exactly. :bigthumb:

rynberg Apr 25, 2005 01:25 AM

To elaborate on what cloed and alberto said:

The PFC can control your boost without the need of an aftermarket controller, because it can activate the stock wastegate solenoid. The problem with this setup is you are relying on a 10+ year old heat-cycled solenoid to do this (unless you have replaced it obviously).

An aftermarket electronic boost controller uses it's own, potentially higher quality, solenoid to actuate the wastegate. The stock solenoid is disconnected and plugged. With an aftermarket ELECTRONIC boost controller installed, the PFC can no longer manage boost -- EXCEPT, it can and will enact fuel-cut if you exceed 0.25 kg/cm^3 boost above the target boost settings. A good rule of thumb is to set the PFC at approximately what boost you are running with your boost controller. That way, it won't fuel cut during normal use but will fuel-cut if something goes wrong with your solenoid/wastegate.


All times are GMT -5. The time now is 07:53 AM.


© 2026 MH Sub I, LLC dba Internet Brands