Starting after sitting awhile...
 

Hi,

I am looking for a help to get my FD started that has been sitting awhile. Like 4 months.

I asked my old folks to start her up every so often and drive around but they just forgot about the fact that I asked them to do that.

I am thinking taking the fuel pump relay out and give a good 10~20 seconds of turn over before starting her up?

It was sitting in the garage covered the whole time.

I have a small request. Could someone please post photo of the location and the relay so I can tell my old folks to do what I need them to do? I am in the west now and the car is in the east. While I am very tempted but I really don't want to fly out there just to start her up. I am trying to get her shipped out my way this month.

Thank you for your help.

Michael

How to start your rotary in 10 easy steps.


Step 1: Unlock car
Step 2: Open door
Step 3: Sit in car
Step 4: Insert key in ignition, turn two clicks forward
Step 5: Say out loud, "It's the remix to ignition, hot and fresh out the kitchen, mama startin' that motor, gotta lube up that rotor."
Step 6: Ensure parking brake is set, gear lever in first
Step 7: Depress clutch pedal and momentarily turn the key to the starting position until the motor starts not to exceed 10 seconds, then release the key. If start was successful, proceed to step 8.
Step 8: Place gear lever in neutral, release clutch pedal
Step 9: ...
Step 10: Profit


https://cimg1.ibsrv.net/gimg/www.rx7...ad3cfc0f5.jpeg



Number 2

Four months isn't all that long, I think you'll be fine. I would be more concerned about the battery going dead if you didn't leave it on a trickle charger.

Only 4 months? charge the battery and start it up.

Actually, I would pull the fuse and crank until you have oil pressure. This is one of the primary causes of premature turbo bearing failure - it sits for a long time (like all winter in NE cars), the oil drains out into the pan leaving dry bearings. You start the car, get the 3000 RPM startup, the turbos wind up to speed, and you have a few seconds of metal on metal.

It's easy to do and cheap insurance.

Really, just pull the EGI fuse, it's easy to pull and on the fuse block on the positive battery terminal. Pull it, crank about 15-20 seconds until you see oil pressure on the oil pressure gauge. Stop, put fuse in, start and drive car as normal.

Dale