Removing tail light ?
 

Took off the tail light and removed the the 6 screws from the backside. Question is, how the heck do I take it apart? I've tried several things but don't wanna break it. I'd hate to screw up and have to pay an arm and a leg for it. Anyone got a simple pic or method?

this has been discussed several times b4...

the trick is to slide the lights to the side... do not pull as u might break it...

Let me c if there's a link... ;)

Here is the link... :D

http://www.jsott.com/rx-7/lights/index.html

I tried the heat gun and it didn't wanna come off. In fact, I have the same one mentioned in the link and used the same temp! I'll try again tomorrow. I must be getting tired. Thanks anyway Cihuuy. :o: zZzZzZzZzZzZzZ

I just pushed mine to the side. Once they pop loose stop pushing or you will break the tab. I didn't use a heat gun or anything :confused:

He is talking about literally taking them apart, probably for the 99 spec conversion. He is not asking how to take the light off the car, I dont think.


I couldnt get my taillight apart with a heatgun etheir...


Here is the link to the how-to..

http://www.jsott.com/rx-7/lights/index.html

i've did about 5- 99 conversions and u just have to reach down low and grab some balls



:D




j/k u need to heat up the lights where the screws r
very hot!

not to melt shit but hold enough i usely take a screw driver and start to pry on it

be careful do not pry on the lens u will crack it ****

keep working at the lights until the glue starts to give then is all comes off

i'm doing another set sone i might post pics


NEVER PRY ON THE LENSES!!!!!!!!!!!!!!!!!!!!

SHIT WILL BREAK

TAKE YOUR TIME AND WORK AT IT



sorry for the miss spelling i'm at work:cool:

I just did the conversion also and used the instructions on the link. I used a screw driver to start the seperation on the outside edge. After 5 mins with the heat gun it should be too hot to start to pull apart with your hands. Pull slowly and be careful of the stringy glue.
Good Luck