Re-amemiya headlight install help!
 

Hello forum, does anyone know or have access to installation instructions for the re-amemiya headlight kit? I acquired a used kit from a front clip with several wires cut from the car.
Can anyone with the kit installed chime in please. Much appreciated!

I have a kit NITB, I'll scan the instructions and send you a pdf. PM me your email.

pm'd you sir!!!!! 1 million forum points for you!

do you need just the wiring or the physical install also?

Hmm... if anyone else has installation instructions for these.... mostly just the wiring part please email them to me too! simonmarques1@gmail.com

wiring can't be too bad for these..what are the questions?

There are (2) yellow cables that come off the harness, where do they go ---- ie. switched power(like most yellow cables) or is it a constant hot.... thats all

If these yellow wires are for the light power, it all depends how you want to wire them...switched or constant doesn't matter. Pic of where the wires come from would help determine what we are trying to find out.

You should be able to tap into existing stock wiring for high, low and ground to operate with your stock headlight on/off switch.

Constant to battery and external switch iwth relay, just make sure you fuse the power wires.

If you have a pic of the harness that would help.

http://i48.photobucket.com/albums/f2...D/relights.jpg

It is the yellow wires in question, everything else is simple - I assume they just plug direct into constant power

“If we worked on the assumption that what is accepted as true really is true, then there would be little hope for advance”

hard to tell how the relays are wired but it appears they are power to a constant (ie battery). I would fuse them.

Does anyone have the directions for this install, Please?

?

i would try emailing the folks at rx7boutique.com they sell them and maybe able to give you a hand

...i was looking for the manual some time ago, but can't find one, but i managed to install the lights without problems. If you take your time, most of the work is pretty straight foward, including the electric parts.

But i would appreciate if anyone who has the manual could put it up here. Should be fixed as a stickie...