race port project UPDATE with pics, and a Question?
here are some pics of my engine install went pretty well AFTER I got the engine in. but have come up across a problem I have a ground wire which I dont seem to remember where it goes? any help would be appreciated.
|
more
|
I believe it connects near the a/c compressor... I remember that one being a bitch when I removed that part of the harness to clean it. Either that or it goes on the middle iron, I can go check in a minute.
|
And I'm wrong... That one should go to a bolt that is either for the starter or bellhousing. The bolt passes through the starter/bellhousing, and has a nut that the ground should go under. Hope this helps.
Jason |
are u sure, I do not remember, can anyone else confirm.
|
Looks to me like the one that goes to the front iron. You'll get to scrape off some of that nice, red paint.
|
That connects to the block, on the intermediate housing right next to the coolant drain plug.
|
I know that there is one that grounds on the starter/bellhousing bolt. Peek down below the oil filter, if you can see one attached to the rear iron, then you've already got it and Eggie is right. If not, put it there.
|
It gos to the steel bracket on the A/C compressor bracket, but anywere on the block will do the same thing.
Paul . http://i3.photobucket.com/albums/y94/Gadd/ACbraket.jpg |
All times are GMT -5. The time now is 02:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands