quick question
 

what is the stock boost pressure of and FD

and does anyone know what a mines ecu upgrade raises it too

any info would help thanks

Boost pattern should be 10-8-10.

thanks

now can anyone help with the Mine's ecu question

this thing is hard to get info on

Generally, the ECU doesn't "raise boost" itself.

Your boost is limited by the amount of fuel you are able to supply for a safe A/F ratio. As far as I know, no 3rd gen owner on the forum here is using a Mine's ECU. However, as they are a chip programmer, the ECU could be programmed to support whatever mods you had.

The stock map sensor is limited to about 17 PSI. So, if you had the ECU fuel mapping, enough CFM and the proper A/F ratio you could run 17 PSI.

The amount of boost you can run is dependent on more components than just the ECU.

well the motor is really fast

and the guy i got it from is crazy and just laughs when i ask him to tell me what is done to it

i blew the turbos up and am now going single so i am tryin to figure out what i should do for a wastegate

i have an upgraded fuel pump and lots of other goodies but i was hoping to get more info on the ecu

thanks for the quick replyz

well the motor is really fast

and the guy i got it from is crazy (in a good way) and just laughs when i ask him to tell me what is done to it

i blew the turbos up and am now going single so i am tryin to figure out what i should do for a wastegate

i have an upgraded fuel pump and lots of other goodies but i was hoping to get more info on the ecu

thanks for the quick replyz