Porting the wastegate
Hey guys, I need to have my wastegate ported, but I'm unsure of what to do about the situation. Some people tell me it's just a simple matter of dremeling out the area under the flapper door, but others are telling me it's a difficult procedure. Is this something someone experienced with a dremel could do, or should I send it to a shop and have it done there? Thanks everyone. ~A-Rod
|
It can be Dremeled but will take a while.
|
its simple...
secure the trubos...level them...get a good drimmel and a grinding bit.. and GOOO SLOOWWWWW...stop and check over and over... |
You use a carbide porting bit first to get the majority of the work done (spray wd40 frequently to avoid burning up the bit and caking). Then you can switch to a dremel to do finer lines... SEARCH NOOB!!! ;)
|
i want to get my wastegat ported but i dont know any mech around me that will do it
|
It does not take experience to do it. I remember when I did my first one and first port job.
It only requires; patience, attention to detail, knowledge of what you are trying to do, and courage. First read all you can find on it, then just do it! |
whell the thing is i would like to find some one who knows what there doing and can do it within 3 days or so because my cars a dd
|
All times are GMT -5. The time now is 08:07 AM. |
© 2024 MH Sub I, LLC dba Internet Brands