Pics of the M2 harness bar?
 

Could someone post up some detailed shots of the M2 harness bar? Thanks in advance.

What part do you need to see?

All of it, I'm going to see if I can get a local shop to make a few for me.

I made mine out of solid aluminum and 1/4" steel mounts for about $35. It is rediculously strong, but a lot of work. The alignment is funky for the end mounts. The $250 off the shelf will save you a lot of time.

-T

I bought the last one, last week.

Jkstill, do you mind taking some pics of the mounts and joints? Also of the eyelets for the harnesses, I'm still not sure exactly how they mount up.

I might try to do something like that instead of copying the M2 bar. Is there anything you would've done differently if you were to do it again?

https://www.rx7club.com/forum/showth...=1#post5269183

Check out that link, lots of pics of the harness bar and mounting points.

PM me if you need any other pics of the harness bar, and I will take some and post them here.

Thanks guys, that should do it.